ASTM D909 Standard Test Method Supercharge Rating of Spark-Ignition Aviation Gasoline
ASTM D909增压法测定航空汽油抗爆特性的标准试验方法
1. Scope
1.1 This laboratory test method covers the quantitative determination of supercharge ratings of spark-ignition aviation gasoline. The sample fuel is tested using a standardized single cylinder, four-stroke cycle, indirect injected, liquid cooled, CFR engine run in accordance with a defined set of operating conditions.
1.2 The supercharge rating is calculated by linear interpolation of the knock limited power of the sample compared to the knock limited power of bracketing reference fuel blends.
1.3 The rating scale covers the range from 85 octane number to Isooctane + 6.0 mL TEL/U.S. gal.
1.4 The values of operating conditions are stated in SI units and are considered standard. The values in parentheses are the historical inch-pound units. The standardized CFR engine measurements and reference fuel concentrations continue to be in historical units.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Annex A1.
2. Referenced Documents (purchase separately)
ASTM Standards
D1193 Specification for Reagent Water
D2268 Test Method for Analysis of High-Purity n-Heptane and Isooctane by Capillary Gas Chromatography
D3237 Test Method for Lead in Gasoline by Atomic Absorption Spectroscopy
D3341 Test Method for Lead in Gasoline--Iodine Monochloride Method
D4057 Practice for Manual Sampling of Petroleum and Petroleum Products
D4175 Terminology Relating to Petroleum, Petroleum Products, and Lubricants
D5059 Test Methods for Lead in Gasoline by X-Ray Spectroscopy
E344 Terminology Relating to Thermometry and Hydrometry
E456 Terminology Relating to Quality and Statistics
D2268 Test Method for Analysis of High-Purity n-Heptane and Isooctane by Capillary Gas Chromatography
D3237 Test Method for Lead in Gasoline by Atomic Absorption Spectroscopy
D3341 Test Method for Lead in Gasoline--Iodine Monochloride Method
D4057 Practice for Manual Sampling of Petroleum and Petroleum Products
D4175 Terminology Relating to Petroleum, Petroleum Products, and Lubricants
D5059 Test Methods for Lead in Gasoline by X-Ray Spectroscopy
E344 Terminology Relating to Thermometry and Hydrometry
E456 Terminology Relating to Quality and Statistics
CFR Engine Manuals
CFRF-4Form893 Supercharge Method Aviation Gasoline Rating Unit Operation & Maintenance
Energy Institute Standard
IP224/02 Determination of Low Lead Content of Light Petroleum Distillates by Dithizone Extraction and Colorimetric Method
Index Terms