ASTM D1534 Standard Test Method for Approximate Acidity in Electrical Insulating Liquids by Color-Indicator Titration
ASTM D1534用比色指示剂滴定法测定电绝缘液近似酸度标准试验方法
The approximate acidity of used electrical insulating oils is an estimate of the total acid value of the oil. As acid values increase, oil quality decreases. This is usually due to oxidation of the oil while in service. In general, acidic by-products produce increased dielectric loss, increased corrosivity, and may cause thermal difficulties attributable to insoluble components called “sludge.” This test method is adapted to a specific volume of oil; total acid values of 0.05 to 0.5 mg of potassium hydroxide per gram of oil is a range which is functionally significant.
1. Scope
1.1 This test method describes the determination of the approximate total acid value of used electrical insulating liquids having viscosities less than 24 cSt at 40°C. It is a simple procedure that can be applied in the field. Where a quantitative neutralization value is required, use Test Method D 664 or Test Method D 974. These test methods should be applied in the laboratory.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately)
ASTM Standards
D664 Test Method for Acid Number of Petroleum Products by Potentiometric Titration
D974 Test Method for Acid and Base Number by Color-Indicator Titration
D1193 Specification for Reagent Water
Index Terms
acidity; color titration; insulating liquid; neutralization number; Acidity, alkalinity, pH; Approximate analysis; Color-indicator titration; Electrical insulating liquids; Total acid/base evaluation;