Precaution, Pretection and Safety, all in FireTC
firetc@firetc.com
 
Inquiry For Fire Testing
 
Recommended Service
Hot Fire test center
 
Your location: Home » Fire test center » Standards & Regulation » USA » Text

ASTM D3747 Standard Specification for Emulsified Asphalt Adhesive for Adhering Roof Insulation

Zoom  Zoom Issue Date:2012-02-10   Browse:1125
ASTM D3747粘合屋顶绝缘用乳化沥青粘合剂
ASTM D3747 Standard Specification for Emulsified Asphalt Adhesive for Adhering Roof Insulation
ASTM D3747粘合屋顶绝缘用乳化沥青粘合剂
This specification covers emulsified asphalt adhesive for use in adhering preformed roof insulation to steel roof decks of specified inclines. When applied as a continuous film over an acceptable deck surface, the emulsion functions as both an adhesive and a vapor retarder. The adhesives shall be appropriately sampled and tested, and shall adhere accordingly to the following physical requirements: water vapor permeance; adhesive strength; freezing resistance; density; residue by evaporation; ash content of residue; and behavior during heat test.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1. Scope
1.1 This specification covers emulsified asphalt adhesive for use in adhering preformed roof insulation to steel roof decks with inclines up to 33 %. When applied as a continuous film over an acceptable deck surface, the emulsion functions as both an adhesive and a vapor retarder.
1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.
1.3 The following precautionary caveat pertains only to the test method portion, Section 5, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately
ASTM Standards
C208 Specification for Cellulosic Fiber Insulating Board
D244 Test Methods and Practices for Emulsified Asphalts
D312 Specification for Asphalt Used in Roofing
D2939 Test Methods for Emulsified Bitumens Used as Protective Coatings
E96/E96M Test Methods for Water Vapor Transmission of Materials
Index Terms
emulsified asphalt adhesive; preformed roof insulation; steel roof decks; surface; vapor retarder;
 
 
[ Fire test center Search ]  [ ]  [ Forword to friends ]  [ Print ]  [ Close ]  [ Back to Top ]

 

 
 
Home | About us | Contact | Terms & Conditions | Copyright | Site Map | Friend link | Guestbook | Old Version | 闽ICP备09009213号
©2013-2015 FIRETC.NET All Rights Reserved   ICP:闽ICP备09009213号-4