ASTM C916 Standard Specification for Adhesives for Duct Thermal Insulation
ASTM C916导管绝热材料用粘结剂
This specification covers minimum material requirements, and safety precautions in application, for adhesives to bond thermal insulation duct liner on the interior surfaces of sheet metal air conditioning ducts; and for coating exposed edges and joints of duct liner thermal insulation to minimize erosion of insulation fibers by air movement. Adhesives shall be classified as follows: Type I; Type II; Type III; and Type IV. The following test methods shall be performed: bonding strength; bond retention after heat aging; flame spread and smoke developed; edge-burning test; storage stability; and precision and bias.
This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
1. Scope
1.1 This specification covers minimum material requirements, and safety precautions in application, for adhesives to bond thermal insulation duct liner on the interior surfaces of sheet metal air conditioning ducts; and for coating exposed edges and joints of duct liner thermal insulation to minimize erosion of insulation fibers by air movement.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see Sections 7 and 9.
2. Referenced Documents (purchase separately)
ASTM Standards
C168 Terminology Relating to Thermal Insulation
D93 Test Methods for Flash Point by Pensky-Martens Closed Cup Tester
D903 Test Method for Peel or Stripping Strength of Adhesive Bonds
D1151 Practice for Effect of Moisture and Temperature on Adhesive Bonds
E84 Test Method for Surface Burning Characteristics of Building Materials
D93 Test Methods for Flash Point by Pensky-Martens Closed Cup Tester
D903 Test Method for Peel or Stripping Strength of Adhesive Bonds
D1151 Practice for Effect of Moisture and Temperature on Adhesive Bonds
E84 Test Method for Surface Burning Characteristics of Building Materials
Other Standards
ACGIH Threshold Limit Values
Index Terms
adhesive; duct liner; insulation; Acoustical materials/applications specifications; Adhesion thermal insulating materials; Air conditioning materials/applications specifications; Bond strength adhesives; Ducts/duct liners; Edge burning test; Thermal insulating materials specifications; Ventilation materials/applications (buildings);